Panel Only

This set includes the front and back panels, all annunciators, knobs, and switch guards.
Note: No electronic components are included. You will need to purchase switches, toggle switches, rotary switches, encoders, or potentiometers separately.

Connect and Play

This is a fully functional unit that must be connected via the IDC connector pins on the back of the PCB to a controller board. Programming is required.
Pin layout information is either printed on the PCB or provided in a separate datasheet.

Plug and Play

This version comes pre-programmed and USB-ready for use with your preferred flight simulation software.
Simply plug it in, install the provided configuration files, and you're ready to fly!

Power Supply Note:
Because the panels can be daisy-chained using their power connectors, single-panel products do not include a 12V power adapter. Only one adapter is required to power your entire custom cockpit setup. The power supply is used solely for the backlighting, not for the product’s core functions.

Knobs

All knobs are high-quality, resin 3D-printed components with realistic designs. They are supplied with a D-shaft fitting.
For modifications or custom requirements, please contact our support team.

Gauges

The gauges are powered by SG90 servo motors, compatible with most available controller boards. Each unit includes one or two pre-mounted servo motors.

Calibration must be done via your software or firmware.

Where specified, we use 28BY stepper motors with a ULN2003 driver board.

Electronics

Electronics are available as complete packages or individual components. When selecting a color or type, you will receive the specified quantity of the chosen product.

PCBs

PCB Only: Includes just the bare PCB. You can order components separately.

PCB + Electronic Components: Includes a blank PCB plus all necessary components for you to solder.

Soldered PCB: Fully soldered and tested by us. Ready to connect to your controller board and program.